Software Instruction Manual

IQ–MSD Turbo 1.4 Advanced IQ System Software
Page 183
to delete and reenter them later.
The following “analog” commands are available for each IQ component:
Amplifier IQ P.I.P. without SmartAmp features:
Attenuation—set the input attenuation level of each channel
Amplifier IQ P.I.P. with SmartAmp features (includes all the above commands plus):
Smooth Output Limiter Threshold—set the point when smooth limiting begins
Stand By Gate Level—set the point when the high voltage supplies turn on
Fault Error Input Drive Level—set the minimum drive level for a fault
MPX-6 Mixer:
Attenuation—set the attenuation level of each input and channel
SMX-6 Mixer (includes all MPX-6 commands plus):
Max Gain—set the maximum gain for an input and channel
Low Set—set the “closed gate” gain for an input and channel
Gate Threshold—set the point when an input gate “opens”
Input Compression Threshold—set the point when input compression begins
Auto Level DAOL—set the Desired Average Output Level of each input and channel
Idle Gain—set the initial level for the Auto Level function when a gate “opens”
Output Compression Threshold—set the point when compression begins
AMB-5 Mixer (includes all MPX-6 commands plus):
Max Gain—set the maximum gain for an input of Channel 1
Low Set—set the “closed gate” gain for an input of Channel 1
Gate Threshold—set the point when an input gate “opens”
Input Compression Threshold—set the point when input compression begins
Auto Level DAOL—set the Desired Average Output Level of each input of Channel 1
Idle Gain—set the initial level for the Auto Level function when a gate “opens”
Output Compression Threshold—set the point when compression begins
Ambience Threshold—set the point when the AMB function will begin to operate
Equalizer:
Output Gain—set the output gain
Filter—set the level of each equalizer filter
Max/Min Level: The Max and Min Levels set the range for a level control. The Max Level is the level
used by the selected command when the input is turned up to its highest setting. The Min Level is the level used
by the selected command when the control at the input is turned down to its lowest setting.