Owner manual

ManualsBrandsCrown Audio ManualsAudio accessoriesP.I.P-RPA

Page 19

Reference Manual

P.I.P.-RPA

A.1 Custom Remote Control

This section describes (1) how to

avoid problems with audio taper pots,

and (2) how to get full-range control

with pot values other than 10 K ohm.

A pot with an audio or log taper is

called an “Autoper” pot. C-taper pots

are similar to A-type pots except the

tape is reversed. The P.I.P.-RPA is

designed to use C-taper pots for

remote level controls.

Crown’s RPA-RMT is the best remote

control because of its C-taper. Com-

mon A-taper sliders can be flipped to

create the C-taper, but A-taper ro-

tary pots can’t be flipped. Linear

pots are not recommended.

Appendix

Important:

This Appendix includes

instructions on how to modify the

P.I.P.–RPA to accommodate special

needs. Only a competent technician

should attempt to make these modi-

fications. Other than the ones de-

scribed here, no other modifications

are approved by Crown. If you have

any questions or need further techni-

cal assistance, please contact the

Crown Technical Support Group at

800-342-6939, or contact your local

representative.

Fig. A.1 Scaling Resistors and Jumpers