Instruction Manual

1313

Figure 2.3 shows different types of mounting conﬁgurations. Depending on the type of mounting you use,

be sure to:

1 Prepare mounting surface. If necessary, weld blocks to mounting structure, drill holes, etc.

2 Fasten beam clamp, screw hook or other type of suspension anchor to hanging point.

3 Attach threaded rod and turnbuckle to anchor. Check that it is securely attached.

4 Attach heater to turnbuckle. Adjust turnbuckle until the heater is level and equal weight distribution is

achieved. Threaded rod must be straight up and down, do not install threaded rod at an angle.

Figure 2.3 • Heater Mounting

DSC Series

2.0 Installation • Heater Mounting

Optional

Mounting bracket

attached to ceiling.

Optional Mounting

bracket attached to

wall.

0° Mounting Angle

30° Mounting Angle

30°

Mounting Angle

0°

Mounting Angle

30°

Bar Joist Clip

Rigid threaded rod

and turnbuckle

(ﬁeld supplied)