Instruction Manual

22
2323
DSC Series
Service Access Panel Removal
Before removing the service access panel on appliance, allow the unit to cool completely before servicing.
To remove the service access panel a ¼” nut driver will be needed.
1 Remove the two ¼” screws on the control end of the unit first while holding the panel in place (see
Figure 4.1).
2 Proceed to the opposite side of the unit while holding the panel in place and remove the last two ¼”
screws.
3 Slowly allow the face to rotate open towards the component side of unit and remove service access
panel.
Failure to support the service access panel during removal can result in damage to the piece and or
uncontrolled dropping of the panel possibly causing injury.
Figure 4.1 • Service Access Panel Removal
WARNING
!
Crown Verity makes every possible effort to remove sharp edges, however, caution should be
taken to avoid contact with potentially sharp edges on the heater housing. Sharp edges may
cut, resulting in personal injury.
4.0 Maintenance • Service Access Panel Removal
1/4” Screw
Service
Access Panel
Control End
1/4” Screw
1/4” Screw
1/4” Screw