Installation Sheet

All electrical components must be
installed by a licensed electrician
in accordance with the National
Electric Code and the appropriate
local electrical codes.
WARNING: This product can expose you to Lead,
which is known to the State of California to cause cancer
and/or birth defects or reproductive harm. For more
information go to www.P65Warnings.ca.gov
ASSEMBLY INSTRUCTION
You will need 12-Cand.BULB
60 watts Max Bulb not included
USE LED BULBS FOR EXTENDED USE
®
MODEL #CLO-8899-AG
28.7″
L:
N:
CRYSTAL SETS:
L:Ø6mmx27,Ø8mmx27,Ø40mmx1
N:Ø30mmx58,Crystal ball with long thread
Ø30mmx58,Crystal ball
24.4″
How to Install
1.Put the Check Ring over the hex nut on top of
wiring box.
2.Thread Rod onto the nipple.
3.Place the top metal plate over the rod and secure it
with hex nut.
4.Pull the fixture wire through the hickey until taut and
put the top cap over it and secure by fixture loop.
20.2″
5.Insert each long threaded crystal ball through the
bottom of the ring, then secure it from the top with
the crystal ball (without nipple).