Datasheet

Document NO.: WI-FHF- CS-PME2SL -A
Page 8of 9
MODEL: CS-PME2SL
REV : A/2
Date : 18 Aug 2015
4.Protection Capability Test Method and Request
保护性能检测与要求
Item
项目
Test Method
检测方法
Request
要求
1
Overcharge Test
过充测试
Apply a 5V voltage and a 1C charge
current on the battery for 10 hours.
用恒压源持续加载 10hs，恒流恒压源电压设定为
5V，电流设定为 1C 的外接电流。
Battery could not be burst, burn, leak and
smoke
电池应不爆炸、不起火、不冒烟或漏液。
2
Over discharge
Test
过放测试
Discharge the battery at 1C to cut off
voltage，then discharge with loading 30Ω
for 24hs.
以 1C 放电至终止电压后外接 30Ω 负载放电 24H。
Battery could not be burst, burn, leak and
smoke
电池应不爆炸. 不起火. 不冒烟或漏液。
3
Over-current
protection
过电流保护
1) The battery is fully charged to rated
capacity.
按标称容量充电方法将电池充饱电。
2) Increase Load current by 0.2A/S until
cut off the output of the battery.
以 0.2A/S 的速度加载线性电流,致使电池切断
输出。
Battery could not be burst, burn, leak and
smoke
电池应不爆炸.不起火.不冒烟或漏液。
4
Pack Short-circuit
Protection
短路保护
1) The battery is charged to rated
capacity.
按标称容量充电方法将电池充饱电。
2) The battery is to be short-circuited by
connecting the positive and negative
terminals of the battery with
thermocouple having a maximum
resistance load of 0.1Ω for 1h.
将接有热电偶的电池置于通风橱中，将电池正
负极用 0.1Ω 电阻器持续短路 1h。
Battery could not be burst, burn, leak and
smoke After charging.
电池应不爆炸、不起火、不冒烟或漏液。
After charging，the battery can be used
normally.
充电后，可正常使用。
5. Cell（电芯）
1) Chem : Lithium Polymer Cell
类别 : 锂聚合物电芯
2) Spec : 053450P*1/3.7V/900mAh （MK）迈科
3) 规格 : 053450P*1/3.7V/900mAh （MK）迈科
6. OUTLINE (外观尺寸):
L=51.96mm MAX W=34.28mm MAX H=5.60mm MAX