Specifications
52-620 (SEALED) Door Jamb Switch for most Ford
and Chrysler products, 14V at 10 Amps Lamp Load
Overall length 2-1/8", Plunger travel 3/16", Self-tapping
thread. Self-Adjusting.
52-622 Mating Connector for 52-620 Switch.
Three 8" 18 gauge wire leads.
52-624 (KIT)
52-620 Switch and 52-622 Mating Connector.
52-616
UNIVERSAL, 5 Amps @ 12V, Screw Terminals "ON"
when plunger is out. Dual Mounting Hole 1-3/8", 2-1/16
on center. REPLACES: Chrysler 882943, KF-204229,
52-623
Door Jamb Switch to accept two Bullet Terminals.
Weather Resistant plastic plunger and body. Accepts
two bullet terminals. Pits panels .030" - .070" thick.
Mo
unting hole .850 diameter. max., 5 Amps @ 12V.
REPLACES: Ford OA1-13713, BOA-13713, B9MT-
13713A, C3AZ-13713A.
52-260
TWO SPEED AXLE SHIFT LIMIT
SWITCH. For use in controlling the
Eaton two speed electric axle.
Phenolic insulator base with O-Rings
on studs. Used with Pollak® #52-261
Axle Switch.
52-104 (N.O.)
HYDRAULIC (60-100 P.S.I.)
Pressure switch
52-261
2 Position Both On controls. High and
Low Axle Ranges. Die-cast body
protected with rubber cover. Three
Female Terminals to receive Bullet
Terminals. For use in controlling the
Eaton two speed electrical axle.
52-623
39
52-620
52-622
52-616
52-633
52-620 with mounting
hardware.
52-625 – Shell for 52-622
52-626 – Boot for 52-622
52-627 – Pin for 52-622
DOOR SWITCHES
AXLE
SWITCH
STOPLIGHT
SWITCH
DIMMER SWITCHES
2 POSITIONS - ON Low Beam) ON (High Beam) S.P.D.T.
AXLE
SWITCH
52-250
UNIVERSAL - Mounts through floorboard.
Three 1/4" - 20 tapped holes, 3/4" and 1-3/4"
on center, With 3 Flat Screw Terminals and 4
Bullet Terminals supplied in separate
hardware kit. 3 Screw Terminals.
52-252
Floor Mounted Type. Mounting holes
1-5/8" on center, 7/32" diameter., 3
Special Terminals, for Plug connection.
52-253
Special Floor Mounted Type.
Mounting holes 1-6/8" on center,
9/32" diameter., 3 Special Terminals
for Plug Connection.