User Guide

MNX10015 / Rev B
4/11/2008 3
Mounting Steps
Note: The term “Sensor” used in the notes below, refers to vibration
sensors. An accelerometer is a type of vibration sensor and can therefore
be used whenever sensor is referenced.
Examples of measurements:
• Dual Outputs for Temperature and Vibration
BNC J1 & 2 pin output – Dynamic Vibration
BNC J2 – Temperature (in Volts DC)
• Dual Outputs for Loop Power and Vibration (typically not used in this
application)
BNC J1 & 2 pin output – Dynamic Vibration
BNC J2 – 4-20mA output
• Requires optional JB905-1A Block to provide power from PLC/DCS
system and to LP series sensor.
Section II
Installation
Measurement
Locator
Card
Portable
Data Collector
Access Points
BNC-J1 for Measurement Point A 2 Pin Output
BNC-J2 for Measurement Point C for Point A
Switch
(4) Position
Blocks
for Sensor
Inputs
(12) Position Blocks
(optional)
for Signal throughput
(not affected by
switch
)
Figure 1. Dual Output Switch Box Layout