Owner manual

CTI Products, Inc. NCB-AY User Guide
2. Setup and Operation 14
C) Add the Control Neuron Processor to the network drawing:
 Drag the Device shape to the drawing. The “New Device Wizard” window will be displayed.
 Specify the desired Device Name.
 Click NEXT to continue.
 In the “External Interface Definition” section, choose ‘Existing Template’, click the down arrow
and choose the appropriate template as follows: NCBTLC30.XIF should be used for the Control
Neuron Processor of an NCB of Version 3, NCBTLC20.XIF should be used for the Control
Neuron Processor of an NCB of Version 2.
 Click NEXT to continue.
 In the “Channel: Name:” section, choose the custom channel connected to Side A of the router that
was created in Step a.
 Click NEXT to continue
 Specify a Location string and Description, if desired. “Ping Interval” can be set as desired,
however should be set to “never” for remote NCBs which are not connected full-time (for example,
those connected via dial-up telephone lines).
 Click FINISH to complete the “New Device Wizard”.
D) Commission the LonWorks router:
 Right-click on the router shape added in step b.
 Click on the Commission function
 Select the Online state.
 Click FINISH to commission the router.
E) Commission the Control Neuron:
 Right-click on the Control Neuron device shape added in step c.
 Click on the Commission function
 Select the Online state and Current Values in Database for Source of Configuration Property
Values.
 Click FINISH to commission the Control Neuron.
Figure 5--LonMaker NCB Diagram