Use and Care Manual

11Section 3 — ASSembly & Set-Up
13. Align template A on the right side of the tractor as shown
in secure in place with the hex screw, nut and screw from
the Snow Cab/Sun Shade Mounting Kit. See Figure 3-21.
Figure 3-21
14. Drill the appropriate holes with the ⁄” drill bit provided in
the Snow Cab/Sun Shade Mounting Kit. See Figure 3-21.
15. Remove template A.
16. Align template B on the left side of the tractor and secure
in place with the hex screws and nuts from the Snow Cab/
Sun Shade Mounting Kit. See Figure 3-22.
Figure 3-22
17. Drill the appropriate holes with the ⁄” drill bit provided in
the Snow Cab/Sun Shade Mounting Kit. See Figure 3-22.
18. Remove template B and begin the Assembly steps on page 6.