Instructions / Assembly

14 se c t i O n 4 — as s e M b l y & in s t a l l a t i O n
Install the chute tube extension onto the chute elbow 15.
by lining up the tabs and sliding the adapter over the
chute elbow, as in Fig. 4-23. Secure the chute adapter by
stretching the chute strap and hooking it onto the grass-
catcher pin previously installed.
Peel the backing off of the self-adhesive foam strip (721-16.
04388) that has been included with your grass collector. Apply
it to the upper chute, flush against the flange as shown in Fig.
24.
With the grass catcher cover open, install the discharge 17.
chute over the chute extension tube, as seen in Fig. 4-25,
and rest the top end into the upper chute support installed
on the right-hand side of the bag support assembly. See
Fig. 4-26.
Note: The groove on the upper chute should be aligned
with the upper chute support, as seen in the inset of Fig.
4-26.
Figure 4-23
Figure 4-26
Figure 4-25
Flange
Figure 4-24