Product Manual

5
ENGLISH
Figure 1
Figure 2
ASSEMBLING THE SNOW BLADE
6. Insertthe3/8"x3-1/2"hexboltthroughthebladeadjust
spring.Assemblea3/8"hexnutabout1"ontotheend
ofthebolt.Seegure1.
3/8" x 3-1/2"
HEX BOLT
BLADE
ADJUST
SPRING
3/8" HEX NUT
PLASTIC
CAP
3/8"
HEX
NUT
BLADE
PIVOT
SHAFT
SPRING
MOUNT
ROD
BLADE
ADJUST
SPRING
HAIR
COTTER
PIN
(LARGE)
PIVOT PLATE
KNOB
HAIR COTTER PIN
(LARGE)
3/8" x 3-1/2"
HEX BOLT
3/8" FLAT
WASHER
7. Toattachthechannelassemblytotheblade,alignthe
pivot plate between the welded brackets on the back of
the blade. Insert the pivot shaft through the holes in the
pivot plate and the welded brackets. Secure the pivot
shaftwiththetwolargehaircotterpins.Seegure2.
8. Hook the blade adjust spring over the spring mount rod
as shown. Insert the bolt through the hole at the top of
thebladeandassemblethe3/8"atwasherandthe
knob onto the bolt. Turn the knob until it is tight. Place
theplasticcapovertheendofthebolt.Seegure2.
NOTE: The blade is now set at the lowest spring tension. To
adjust the tension see the Adjustments section.
Figure 4
HINT: The lift handle will assemble more easily in the
following instruction if bricks or blocks of wood are placed
under the bottom edge of the blade.
10. Insert the end of the lower lift handle assembly through
the notch in the pivot support bracket and through the
holes in the channel assembly. Align the lift link pin with
the hole in the welded bracket on the lower lift handle
assembly. Insert the lift link pin through the hole in the
bracket and secure it with a small hair cotter pin. See
gure4.
LOWER LIFT
HANDLE ASSEMBLY
WELDED
BRACKET
LIFT
LINK
PIN
HAIR
COTTER PIN
(SMALL)
CHANNEL
ASSEMBLY
9. Attach the channel assembly to the tractor by placing
the end of the channel inside the pivot support bracket.
Assemblethe1/2"atwasherontothechannelpivotpin
and insert the pin through the holes in the pivot support
bracket and the channel. Secure with a small hair cotter
pin.Seegure3.
1/2" WASHER
CHANNEL
PIVOT
PIN
CHANNEL
ASSEMBLY
HAIR
COTTER PIN
(SMALL)
PIVOT
SUPPORT
BRACKET
Figure 3