Warranty

1. Place a bumper cap onto each end of the front bumper

tube. See Figure 1-2.

Figure 1-2

2. Position the bumper brackets to the inside of the tractor’s

frame and secure it in place with the four hex flange screws

or four hex screws and four flat washers, depending on

what this kit includes. See Figure 1-3.

Bumper mounts on the

inside of the tractor frame.

Figure 1-3

Model 19A30020100 front bumper kit is designed for use with

select Cub Cadet lawn tractors. Refer to your lawn tractor’s

Operator’s Manual to assure compatibility.

Carton Contents

Before beginning installation, remove all parts from the carton to

make sure everything is present. Carton contents are listed below

and shown in Figure 1-1. Part numbers are shown in parentheses.

• Two Bumper Caps (731-05368)

• One Bumper Assembly (683-05155)

• *Four Hex Flange Screws (710-06012A)

*Some Kits will have instead:

• Four Hex Screws (710-06012)

• Four Flat Washers (736-0262)

Figure 1-1

Installation Instructions

WARNING: Before beginning installation, place

the tractor on a firm and level surface, set the

parking brake, place the PTO in the disengaged

(OFF) position, stop the tractor’s engine and remove

the ignition key to prevent unintended starting.

InstallatIon Manual

Front Bumper Kit — 19A30020100

Form No. 769-10616

February 4, 2015

CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019

Printed In USA

PAGE 1
Installation Manual Front Bumper Kit — 19A30020100 Model 19A30020100 front bumper kit is designed for use with select Cub Cadet lawn tractors. Refer to your lawn tractor’s Operator’s Manual to assure compatibility. 1. Place a bumper cap onto each end of the front bumper tube. See Figure 1-2. Carton Contents Before beginning installation, remove all parts from the carton to make sure everything is present. Carton contents are listed below and shown in Figure 1-1. Part numbers are shown in parentheses.