Use and Care Manual

8 Section 3— ASSembly & Set-Up
Installing the Snow Cab
NOTE: If you purchased the Sun Shade kit (Part #19A30021100)
alone, you can order the Snow Cab attachment (790-00712)
seperately.
NOTE: To help remove any wrinkles in the snow cab, leave the
snow cab unfolded out in the sun.
1. Unfold the snow cab and lay it over the top of the frame.
Make sure that the silver/gray reflector along the upper rear
of the back window is facing towards the rear of the tractor.
See Figure 3-9.
Figure 3-9
2. Remove the backing tape on the reflector labels and install
the labels on the outside of the cab as shown in Figure 3-10.
Figure 3-10
3. There are five clips around the base of the snow cab, three
on the back and one each on the left and right side.
4. The rear center clip clips onto the center of the fender. See
Figure 3-11.
Figure 3-11
5. The outer rear clips clip onto the fenders near the wheels.
See Figure 3-12.
Figure 3-12