Use and Care Manual

9Section 3 — ASSembly & Set-Up
6. The outer front clips attach to the front fenders near the
wheels. See Figure 3-13.
Figure 3-13
7. A bungee strap runs over the front of the hood. This strap is
used to tighten the snow cab around the hood and prevent
snow from entering the cab. The hooks of the strap are
hooked onto the hood near the front wheels. See Figure 3-14.
Figure 3-14
8. Unzip the cab door and locate the five straps inside the
cab. There is one in the front (near the hood) and a four
along the top. Snap the ends of each strap together and
then tighten them securely. See Figure 3-15.
Figure 3-15
9. A pair of magnets are on the bottom section of each side of
the floor boards. These magnets help hold the lower portion
of the snow cab against the floorboards. See Figure 3-16.
Figure 3-16