Warranty

13Section 4 — ASSembly & inStAllAtion
1
2
Figure 4-22
5. Pivot the discharge chute rearward until the hole in the
discharge chute elbow aligns with the pin on the deck
adapter. Move the discharge elbow down onto that pin as
shown in 2 of Figure 4-22.
6. Secure the discharge chute elbow to the cutting deck using
a (720-04122) wing knob included in hardware pack 689-
00341. Refer to Figure 4-23.
Figure 4-23
5. Secure the discharge chute elbow to the cutting deck using
a (720-04122) wing knob included with the bagger kit.
Refer to Figure 4-20.
Figure 4-20
On 50” and 54” Stamped Decks:
1. Raise the deck to its highest position.
2. Remove the deck pin rubber protective cap, 1 in Figure
4-21.
3. Raise the chute deflector (2 in Figure 4-21) on the deck and
hold it while you install the (731-10133) chute adapter(3),
included in hardware pack 689-00341, onto the deck as
shown in Figure 4-21.
1
3
2
Figure 4-21
4. Insert the end of the discharge chute elbow (1) into the
hole provided in the deck wheel mount as shown in the
inset of Figure 4-22.