Warranty

12 Section 4 — ASSembly & inStAllAtion
24. Install the bagger cover onto the bag support assembly, as
seen in Figure 4-18. The plastic cover goes inside of the two
mounting tabs.
Cover mounts in
between these
two tabs
Figure 4-18
25. Slide the hinge pin into the hole located on the mounting
tab, as in Figure 4-19. Use the cut-out window (See inset in
Figure 4-19) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Figure 4-19.
Figure 4-19
22. If not already assembled by the factory, install the bagger
screen into the bagger cover by first inserting the end
closest to the center into the cutout mounting hole, as in
Figure 4-16. Make sure to feed the screen under the lip, as
in Figure 4-17.
Figure 4-16
23. Clip in the other side by flexing the screen and pushing it
down into the provided cutout hole. See Figure 4-17.
Make sure screen sits under the cover’s lip
Figure 4-17