Warranty

Assembly & Installation
4
8
CAUTION: Do not attempt to install this bagging
attachment on the tractor while it is still hot from
operation. Do not attempt to install this bagger until
the tractor has fully cooled down.
NOTE: References to left, right, front and rear of the tractor are
from the operator’s position, unless otherwise stated.
• Before assembly, place the tractor on a firm, level surface,
disengage the PTO, stop the tractor engine and set the
parking brake.
• For convenience, pivot the seat forward and leave it in
that position until the grass collector is fully mounted and
assembled.
Remove Existing Rear Bumper
Installation of this triple bagger requires that the existing
bumper be removed and discarded, and a new bumper must be
installed. To complete this configuration, follow these steps:
1. Remove the rear bumper by removing the six (6) screws
that secure it. See Figure 4-1.
NOTE: Discard the bumper and hardware, as it will not be
needed.
2. Remove the hitch plate, if present, from the bumper, and
retain for later installation steps.
Figure 4-1
3. Remove the two (2) muffler shield mounting brackets as
shown in Figure 4-2. Retain these brackets and screws for
reinstallation.
Figure 4-2
4. Remove the muffler shield as shown in Figure 4-3.
Figure 4-3
5. Remove the muffler deflector, as shown in Figure 4-4, by
removing the four (4) screws that secure it.