Instruction Manual

IMPORTANT:

If gear selector buttons fail to work after

making brake adjustment, adjust brake switch actuator

upwards. If it is found that the gear selector buttons

operate before the vehicle comes to a complete stop,

adjust brake switch actuator downwards. To adjust,

loosen brake switch actuator bolts, then move the

actuator up or down accordingly. See Figure 21.

Figure 21

• Cautiously complete the testing on level ground by

operating the machine and applying brakes in a

normal manner.

• Repeat the adjustment procedure if necessary.

Adjusting Throttle Pedal

The throttle pedal assembly can be adjusted for comfort

slightly higher or lower by lining up the holes of the

lower pedal assembly with either the upper two or lower

two holes of the upper pedal assembly. See Figure 22.

Figure 22

Cleaning

The body panels are scratch and impact resistant

automotive quality ABS plastic. The use of standard car

wash soap and non-abrasive car wax is acceptable for

cleaning the body panels. Avoid any abrasive cleaner

or rubbing compounds for these will damage the body

panels. Dry thoroughly to avoid water spots.

WARNING: DO NOT use a pressure washer.

Damage may occur if direct hose spray

comes in contact with intake openings, or any

other electrical components, i.e. at instru-

ment cluster or under dash.

Brake Switch

Actuator

Brake Switch

Actuator Bolts

Lower Pedal

Upper Pedal Assembly

Brake

Pedal Assembly

(Shown for

reference)

Line up here

Assembly