Full Product Manual

13Section 4 — controlS and FeatureS
LCD Service Minder and Hour Meter
(If Equiped)
When the ignition key is rotated out of the STOP position but not
into the START position, the LCD Service Minder and Hour Meter
will briefly display the battery voltage, followed by the tractor’s
accumulated hours.
NOTE: Hours of mower operation are recorded any time the
ignition key is rotated out of the STOP position, regardless of
whether the engine is started.
Change Oil
The LCD will display the letters “CHG”,
followed by the letters “OIL”, followed by
the letters “SOON”, then finally followed
by the meter’s accumulated time. “CHG/OIL/SOON/TIME” will
alternate on the display for seven minutes after the meter
reaches 50 hours. This oil service minder interval will occur
every 50 hours for the following two hours. Before the interval
expires, change the engine oil as instructed on page 18 in the
Maintenance section of this Operator’s Manual.
Low Battery
At startup, the battery voltage is briefly displayed then changes
to accumulated hours. The letters “LO” will display followed by
the letters “BATT” and then followed by the meter’s accumulated
time. “LO/BATT/TIME” is displayed on the LCD when the voltage
drops below 11.5V. When this occurs, the battery is in need
of a charge or the engine’s charging system is not generating
sufficient amperage. Charge the battery as instructed on page
24 in the Service section of this manual or have the charging
system checked by your local service dealer.