Full Product Manual

10 Section 3— ASSembly & Set-Up

3. Rotate the seat into position and secure the seat into place

with the previously removed shoulder screws and flange

lock nuts. Be careful not to crimp or damage the wire

harness while installing the seat. See Figure 3-3.

Figure 3-3

4. Using the harness clip attached to the harness, secure the

excess wire to the fender by snapping the harness clip in

place as shown in Figure 3-4.

Figure 3-4

Lower Deck Discharge Chute Deflector

WARNING! Never operate the mower deck

without the chute deflector installed and in the

down position.

1. Check the mower deck for a shipping brace that may be

holding the chute deflector upward for shipment. If the

brace is present, it must be removed before operating the

tractor. Holding the chute deflector fully upward, remove

the shipping brace. Lower the chute deflector and discard

the shipping brace. See Figure 3-5.

Figure 3-5

Installing the Hood Topper (If necessary)

To install the hood topper (1), line up the holes on the hood topper (1)

up with the tabs (2) in the hood frame as shown in Figure 3-6. Insert

the tabs (2) into the hood topper and pull back to lock into place.

Figure 3-6