Product Manual

11Section 3 — ASSembly & Set-Up
Installing the Hood Topper (If necessary)
To install the hood topper, line up the tabs on the hood topper
up with the holes in the hood frame as shown in Figure 3-7. Insert
the tabs into the hood frame and pull back on the hood topper
to lock into place.
Figure 3-7
Installing the Steering Wheel (If necessary)
The hardware for attaching the steering wheel has been packed
within the steering wheel, beneath the steering wheel cap.
Carefully pry off the steering wheel cap and remove the hardware.
1. With the wheels of the tractor pointing straight forward, place
the steering wheel over the steering shaft. See Figure 3-8.
Figure 3-8
2. Secure the steering wheel with the hex bolt from under the
cap.
3. Place the steering wheel cap over the center of the steering
wheel and push downward until it “clicks” into place.
Installing the Front Bumper (If necessary)
The hardware for attaching the front bumper is shipped installed
into the bumper.
1. Remove the four hex screws from the bumper.
2. Position the bumper brackets to the inside of the tractor’s
frame and secure it in place with the four hex flange
screws. See Figure 3-9.
Figure 3-9
Adjusting the Seat
To adjust the position of the seat, lift the seat adjustment lever
up. Slide the seat forward or rearward to the desired position;
then release the adjustment lever. Make sure seat is locked into
position before operating the tractor. See Figure 3-10.
Figure 3-10