Use and Care Manual

11Section 3 — ASSembly & Set-Up

Installing the Dash Cap (If necessary)

To install the dash cap (1), line up the tabs (2) on the dash cap (1)

with the holes in the upper dash as shown in Figure 3-7. Slide the

tabs (2) into the holes in the upper dash and push forward on the

dash cap (1) to lock into place.

Figure 3-7

NOTE: Be sure to press on the lower part of the dash cap

(3) facing the operator position to ensure the lower tabs on

the dash cap are in place.

Installing the Steering Wheel (If necessary)

The hardware for attaching the steering wheel has been packed

within the steering wheel, beneath the steering wheel cap.

Carefully pry off the steering wheel cap and remove the hardware.

1. With the wheels of the tractor pointing straight forward, align

the steering wheel by using the center-line on the front of the

steering wheel pointing straight ahead and the flat section of

the steering wheel facing toward the seat, place the steering

wheel over the steering shaft. See Figure 3-8.

Center-Line

Flat

Figure 3-8

2. Secure the steering wheel with the hex bolt from under the

cap and torque to 18-22 ft./lbs.

3. Place the steering wheel cap over the center of the steering

wheel and push downward until it “clicks” into place.

NOTE: The bolt securing the steering wheel has thread

locker applied to it, so if it is removed, it is recommended

that the bolt be replaced or thread lock re-applied.

Installing the Front Bumper (If necessary)

The hardware for attaching the front bumper is shipped installed

into the bumper.

1. Remove the four hex screws from the bumper.

2. Position the bumper brackets to the inside of the tractor’s

frame and secure it in place with the four hex flange

screws. See Figure 3-9.

Figure 3-9