Operator`s manual

Problem Cause Remedy
Engine fails to start  
2. Parking brake not engaged.
 Spark plug wire disconnected.
4. Throttle/Choke control lever not in correct
starting position.
5. Fuel tank empty, or stale fuel.
6. Blocked fuel line.
7. Faulty spark plug.
8. Engine flooded.
9. Fuse(s) blown.
 
2. Engage parking brake.
 Connect wire to spark plug.
4. Place Throttle/Choke lever to FAST position.
5. 
old) gas.
6. Clean fuel line and replace fuel filter.
7. Clean, adjust gap or replace plug.
8. Crank engine with throttle in FAST position.
9. Replace fuse.
Engine runs erratic  Tractor running with Throttle/Choke
activated.
2. Spark plug wires loose.
 Blocked fuel line or stale fuel.
4. Vent in gas cap plugged.
5. Water or dirt in fuel system.
6. Dirty air cleaner.
 Push Throttle/Choke control in.
2. Connect and tighten spark plug wires.
 Clean fuel line; fill tank with clean, fresh
gasoline and replace fuel filter.
4. Clear vent or replace cap if damaged.
5. Drain fuel tank. Refill with clean, fresh
gasoline.
6. Replace air cleaner paper element or clean
foam precleaner.
Engine overheats  Engine oil level low.
2. Air flow restricted.
 Fill crankcase with proper amount and
weight of oil.
2. Clean grass clippings and debris from around

Engine hesitates at high
RPM
 Spark plug gap too close.  Remove spark plug and reset the gap.
Engine Idles rough  Spark plug fouled, faulty or gap too wide.
2. Dirty air cleaner.
 Replace spark plug. Set plug gap.
2. Replace air cleaner element and/or clean
pre-cleaner.
Excessive vibration  Cutting blade loose or unbalanced.
2. Damaged or bent cutting blade.
 Tighten blade and spindle.
2. Replace blade.
Mower will not mulch grass  Engine speed too low.
2. Wet grass.
 Excessively high grass.
4. Dull blade.
 Place Throttle/Choke control in FAST (rabbit)
position.
2. Do not mulch when grass is wet.
 Mow once at a high cutting height, then
mow again at desired height or make a
narrower cutting swath.
4. Sharpen or replace blade.
Uneven cut  Deck not leveled properly.
2. Dull blade.
 Uneven tire pressure.
 Perform side-to-side deck adjustment.
2. Sharpen or replace blade.
 Check tire pressure in all four tires.
Tro ubleshooting
8
29