Full Product Manual

13Section 3 — controlS & operation
Reverse Pedal (P)
The reverse drive pedal is located
on the right side of the tractor along
the running board. Ground speed is
also controlled with the reverse drive
pedal. The further downward the
pedal is pivoted, the faster the tractor
will travel. The pedal will return to
its original position when it’s not
pressed.
Brake Pedal (Q)
The brake pedal is located on the left side of the
tractor, along the running board. It is used to stop
the forward or reverse motion of the tractor.
Park Brake/Cruise
Control Lock Pedal (R)
The park brake/cruise control lock
pedal is located on the left side of
the base of the steering column
on tractors with tilt steering and
at the base of the steering column
on all other tractors. It is used to
engage the park brake when the
tractor is at rest. Engaging the
lever while the tractor is in motion
allows the tractor to remain at a
constant ground speed without
applying pressure to the forward
drive pedal. Refer to the Operation
section of this manual for detailed
instructions regarding the parking
brake as well as the cruise control
feature.
NOTE: Cruise control can NOT be
engaged at the tractor’s fastest
ground speed. If the operator
should attempt to do so, the tractor
will automatically decelerate to the
fastest optimal mowing ground
speed
NOTE: The park brake must be set if the operator
leaves the seat with the engine running or the
engine will automatically shut off.
WARNING
Never leave a running machine unattended. Always
disengage PTO, set parking brake, stop engine and remove
key to prevent unintended starting.
Tilt Steering Pedal (S)
The tilt steering pedal is located on the right of the
base of the steering column. When the tilt steering
pedal is depressed and held down, the steering
column can be tilted up or down into one of the six
available positions. To lock the steering column in
place, release the tilt steering pedal and move the
steering wheel column up or down until the steering
wheel column clicks (locks) into the nearest position.
12V Power Outlet (T)
The 12V power outlet is located inside the storage
tray on the steering column and is used for the
convenience of plugging in accessories that require
a power source with a maximum load of 5A at 12V.
Steering Column Storage Tray (U)
The steering column storage tray is located on the
steering column.
Headlight (Not shown/If equipped)
The headlight is located on the front of the
steering column on some tractors with tilt
steering. The headlight is illuminated when the key
is in the “ON “ position.
Operation
General Safety
• RECEIVE INSTRUCTION — Entirely read
this operator’s manual. Learn to operate
this machine SAFELY. Do not risk INJURY or
DEATH. Allow only those who have become
competent in its usage to operate this tractor.
• Before starting the engine or beginning
operation, be familiar with the controls. The
operator should be in the operator’s seat.
The PTO switch must be in the disengaged
position and the parking brake engaged.
• Keep all shields in place. Keep away from
moving parts.
• NO RIDERS! Keep all people and pets a safe
distance away. Look behind and down to
both sides of the tractor before and while
backing up.
• DO NOT direct the mower discharge at
people.
• Avoid slopes where possible. Never operate
on slopes greater than 15°. Slopes with a
greater incline present dangerous operating
conditions. Tractors can be rolled over.
• Before leaving the operator’s seat shut off
the PTO and engage the parking brake,
shut off the engine and remove the ignition
key. Wait for all movement to stop before
servicing or cleaning.
• Avoid any sudden movements of the steering
wheel when starting and stopping. Keep a
firm grip on the steering wheel.
• Be careful when operating near roadways.
Stop the tractor motion and wait for vehicles
to pass before operating along the road.
• Do not operate the tractor with the mower
deck removed. Removal of the deck will
change the balance of the tractor, and could
contribute to a tractor rollover.
• Avoid operation on traction surfaces that
are unstable; use extreme caution if the
surface is slippery.
• Slow down before turning and come to
a complete stop before any zero turn
maneuver.
• Do not stop the tractor or park the tractor
over combustible materials such as dry
grass, leaves, debris, etc.
• Do not fill the fuel tank when the engine is
running or while the engine is hot. Allow
the engine several minutes to cool before
refueling. Tighten the fuel cap securely.
Before Operating Your Tractor
• Before you operate the tractor, study this
manual carefully to familiarize yourself
with the operation of all the instruments
and controls. It has been prepared to help
you operate and maintain your tractor
efficiently.
• This engine is certified to operate only on
clean, fresh, unleaded regular gasoline.
For best results, fill the fuel tank with only
clean, fresh, unleaded gasoline with a pump
sticker octane rating of 87 or higher.
• Unleaded gasoline is recommended
because it leaves less combustion
chamber deposits and reduces harmful
exhaust emissions. Leaded gasoline is not
recommended and must not be used where
exhaust emissions are regulated.
NOTE: Purchase gasoline in small quantities.
Do not use gasoline left over from the
previous season, to minimize gum deposits
in the fuel system.
• Gasohol (up to 10% ethyl alcohol, 90%
unleaded gasoline by volume) is an
approved fuel. Other gasoline/alcohol
blends are not approved.
• Methyl Tertiary Butyl Ether (MTBE) and
unleaded gasoline blends (up to a maximum
of 15% MTBE by volume) are approved
fuels. Other gasoline/ether blends are not
approved.
• Check the engine oil level.
• Clean the air cleaner element if necessary.
• Check the tire inflation pressures.
• Adjust the seat for operator’s maximum
comfort, visibility and for maintaining
complete control of the tractor.
Safety Interlock Switches
This tractor is equipped with a safety interlock
system for the protection of the operator. If the
interlock system should ever malfunction, do
not operate the tractor. Contact your authorized
service dealer.
• The safety interlock system prevents the
engine from cranking or starting unless the
parking brake is engaged, and the PTO knob
is in the disengaged (OFF) position.
• The engine will automatically shut off if the
operator leaves the seat before engaging
the parking brake.
WARNING
Do not operate the riding mower if the safety interlock
system is malfunctioning. This system was designed for
your safety and protection.