Yard Vacuum/Chipper Operator's Manual

10
To Empty Bag
1. a. Unhook bag straps from the lower handle.
b. Unsnap bag clip from the top of lower handle. See
Figure 4-3.
c. Grasp bag handle with one hand and pull lock rod
on mounting bracket with other hand toward engine
to release.
d. Lift bag off back of unit.
2. Twist the two buttons on the back of the bag to unlock
and empty contents. See Figure 4-4. Hold bag handle
and bag clip while emptying the contents.
3. Compress bag opening and fold inner flap over
opening.
4. Fold outer flap over inner flap and insert buttons on
the bag through metal outlets. See Figure 4-4.
5. Twist the buttons to lock bag. Place bag back onto unit
as instructed SETTING UP YOUR CHIPPER SHRED-
DER VACUUM.
WARNING: Do not at any time make
any adjustments without first stopping
engine and disconnecting spark plug
wire.
Using The Nozzle Vacuum
Yard waste such as leaves and pine needles can be
vacuumed up through the nozzle for shredding. After
material has been shredded by the flail blades on the
impeller assembly, it will be discharged into catcher bag.
Do not attempt to shred or chip any material other than
vegetation found in a normal yard (i.e. branches, leaves,
twigs, etc.) Avoid fibrous plants such as tomato vines until
they are thoroughly dried out. Materials such as stalks or
heavy branches up to 1 1/2” in diameter may be fed into
the chipper chute.
1. Place nozzle/hose vac lever in the top position on the
nozzle to vacuum through nozzle. See Figure 4-5.
2. The spring loaded pin must be in the first hole (closest
to the end of the tube) of the hose adapter to operate
the nozzle vac. See Figure 4-5.
3. Place both hands on top of upper handle to push unit
over yard waste.
WARNING: Do not attempt to shred,
chip, or vacuum any material larger
than specified on the machine or in this
manual. Personal injury or damage to the machine
could result.
4
Figure 4-3
Figure 4-4
Figure 4-5
Outer Flap
Inner
Flap
Buttons
A
B
C
D
Operating
Your
Chipper
Shredder
Vacuum