Yard Vacuum/Chipper Operator's Manual

7
3
Attaching The Hose Assembly
5. a. Slide hose adapter of hose assembly into the base
adapter located on the left front of the Chipper
shredder Vacuum. See Figure 3-4.
b. Pull spring loaded pin out on the base and align pin
with the first hole (closest to the end of the tube) in
the hose adapter.
c. Release the pin to lock the hose in place.
6. a. Snap the hose handle first into the upper hose
handle bracket and then into the lower hose handle
bracket. See Figure 3-5.
b. Lay hose tubing on hanger bracket next to chipper
chute. See Figure 3-5.
Attaching The Bag
7. Grasp bag handle with one hand and slide locking rod
on mounting bracket with other hand toward engine.
Use the end of mounting bracket as leverage when
sliding the locking rod.
a. Slip bag over the rim of the discharge opening and
release locking rod to secure bag in place. See
Figure 3-6.
b. Snap bag clip to the top of the lower handle.
c. Place the lower straps on the bag over the top
of lower handle, hooking them on the studs. See
Figure 3-6.
NOTE: The bag/chute switch button attached to the
mounting bracket must be fully depressed by the tip of
front tab on bag handle when securing the bag or engine
will not start.
Figure 3-6
Figure 3-5
Figure 3-4
A
B
Align pin
with this
hole.
A
B
C
B
A
Setting
Up Your
Chipper
Shredder
Vacuum