PAH NOTE: This Operator's Manual covers several models, Tractor features may vary by model. Not all features in this manual are applicable to all tractor models and the tractor depicted may differ from yours. NOTE: All references in this manual to the left or bight side and front or back of the tractor are from the operating position only. Exceptions, if any, will be specified, Preparation MANUALLY MOVING TRE TRACTOR 1.
SEMI b. Perforate Adjust seat use flange lock nuts (3) and flat washers (b). See Figure 5. Figure 5 3. If necessary, securely connect the seat switch wiring shames {a) tithe seat switch (b). See Figure 6, Secure excess wire away from pinch points before continuing, Figure & NOTE: Tractor will not operate without the seat switch wiring harness connected. Position Lap bar Drive Control Levers The lap bar drive control fevers can be adjusted up/down and forward/backward for the operators comfort.
ASSEMBLY 3. Place the chute deflector on the deck, be sure to Insert the tabs on the chute deflector into the holes on the deck. See Figure 9, Figure 9 4. Slide the chute deflector toward the rear of the tractor until the bolt hole in the chute deflector aligns with the hole in the deck. See Figure 9. 5. Secure the chute deflector in place with the flange lock nut and hex screw removed in Step 2. Tighten to 102-124 in-lbs {115-14 N-m).
SEMI A WARNING Should battery acid accidentally splatter into the eyes or ont the skin, rinse the affected area immediately with clean cold water. Seek prompt medical attention, if acid spills on clothing, first dilute it with clean water, then neutralize with a solution of ammonia/water or baking soda/water. NEVER connect {or disconnect) battery charger clips to the battery white the charger is turned on, sit can cause sparks.
ASSEMBLE BATTERY MAINTENANCE Some batteries are filled with battery acid and then sealed at the factory. However, even a “maintenance free” battery requires some maintenance to ensure its proper life cede, Spray the terminals and exposed wire with a battery terminal sealer, or coat the terminals with a thin coat of grease or petroleum jelly, to protect against corrosion. Always keep the battery cables and terminals clean and free of corrosion.
AREA] CHARGING THE BATTERY LEVER ADJUST Te stand, if necessary, recharge the battery after the tractor has 1. Push left and hold the seat adjustment lever to adjust the been stored for 2 period of time. seat position, Models with Lead-Acid Battery 2. Slide seat forward or rearward to desired position. | + Avoltmeterorioad tester reading of 124 volts (DC) follower 1. Release the adjustment lever, Ensure seat is locked into across the battery terminals indicates that the battery position before operation.