Product Manual

29
PRODUCT CARE
60” Decks
(a)
(b)
(c)
(c)
(d)
(d)
Figure 42
Tractor Blade Care
WARNING
Tractor blades are sharp. Wrap the blade or wear gloves
and use extra caution when servicing them.
The cutting blades must be kept sharp at all times. Sharpen the
cutting edges of the blades evenly so that the blades remain
balanced and the same angle of sharpness is maintained.
If the cutting edge of a blade has already been sharpened many
times or if any metal separation is present, it is recommended
that new blades be installed. New blades are available at your
authorized dealer.
The blades may be removed as follows:
1. Remove the deck from beneath the tractor, (refer to
Deck Removal) then gently flip the deck over to expose
its underside.
2. Use a 15/16” wrench to hold the hex nut on top of the spindle
assembly when loosening the hex nut (a) and washer (d)*
securing the blade (b). A block of wood (c) may be placed
between the deck housing and the cutting edge of the blade
(b) to help in breaking loose the hex nut (a) and washer (d)*.
See Figure 43.
(a)
(d)
(c)
(b)
*
* If equipped
* If equipped
Figure 43
3. When re-installing the blades, be sure of the following (see
Figure 43):
a. Blades (b) are installed so wings are pointing upward
toward the top of the deck.
NOTE: When replacing or installing the blades, be sure to
install with the side marked “Bottom” or “Grass Side” (or with
a part number stamped on it) facing the ground when mower
is in operating position.
b. Washer (d)* is placed between bottom of blade (b) and
hex nut (a).
IMPORTANT! Align “S” shaped cutout with matching “S”
shape on spindle for secure fit.
4. Tighten the hex nuts (a) to 70-90 ft-lbs (95-122 N-m).
5. Re-install the deck (refer to Deck Installation).
Changing the Transmission Drive Belt
Several components must be removed and special tools used
in order to change the tractor’s transmission drive belt. See
your authorized service dealer to have the transmission drive
belt replaced.
Tractor Creeping
Creeping is the slight forward or backward movement of the
tractor when the throttle is on and the speed control pedals are
in the neutral position. If your tractor creeps, see an authorized
service dealer.