Use and Care Manual

CARE AND MAINTENANCE

IMPORTANT

First-time use: It is important that the grill be lit and allowed to heat up for at least 30 minutes before any food is

placed on the cooking grid. It is normal for some smoke to appear during the initial operation of the grill. After initial

heating, the grill is ready for use. A cooking spray can be used on the cooking grids to allow easier clean up.

THIS COOKING APPLIANCE IS FOR OUTDOOR USE ONLY AND SHALL NOT BE USED IN A BUILDING,

GARAGE OR ANY OTHER ENCLOSED AREA.

MOVING INSTRUCTIONS

Caution: Never move the grill with burner lit.

• Make sure control knob is in the “OFF” position. Disconnect the propane cylinder from the regulator.

• Be sure the grill has completely cooled for at least 30 minutes.

• Close the lid and secure the latch. Remove and clean grease tray, then reinstall. Place the legs in the down

position. Use the handle to carry the grill.

Note: It is best to leave the grease tray in place attached to the bottom of the grill-some grease may continue to

drip from drain hole during transport.

DOOR ADJUSTMENT

The 3-in-1 Pizza Oven Plus is designed for optimal performance right out of the box. After repeated use and heating of the

unit, your pizza oven door may require a slight adjustment. If while using your 3-in-1 Pizza Oven Plus you feel that the pizza

oven door latch is too tight or too loose, follow the instructions below to tune the latch to your own personal preference.

There is also a short instructional video on our YouTube channel (@CuisinartBBQ) to assist with this adjustment. If you require

further assistance, please contact our consumer care department Monday-Friday, 9am-5pm EST by phone at 1-866-994-

6390 or by email at consumercare@thefulhamgroup.com.

• Remove the latch holder from the

front of the lid using a Phillips head

screwdriver.

• Using a at-head screw driver, rotate the

screws on both sides of the latch holder

a ¼ turn counter-clockwise or clockwise

to either loosen or tighten the latch holder

according to your personal preference.

STEP 1

--------------------------------------------------------------------------------------

STEP 2

--------------------------------------------------------------------------------------

STEP 3

--------------------------------------------------------------------------------------

• Re-install the latch holder to the front of

the lid using a Phillips head screwdriver.