Service manual

CULLIGAN HOUSEHOLD & COMMERCIAL CIRCUIT BOARDS
16
Press  to increase or
 to decrease
Press  to increase or
 to decrease
Press  to increase or
 to decrease
Press  to increase or
 to decrease
1. With a flashing or blank display, pressing the status button twice
will move to the Time-of-Day adjustment, adjust the time by
using the up and down arrows. A number “1” will appear at the
bottom of the display while in this mode.
2. Press status again, this displays the Time-of-Regeneration for
delayed units, adjust using the up and down arrows. A number
“2” will appear at the bottom of the display while in this mode.
3. Press status again, the number “3” will appear at the bottom of
the display. This setting is not used, and any changes made
will not affect the operation of the microprocessor.
4. Pressing status again displays the Fast Rinse Time (for
Culligan Platinum Series
™
Units Only). A “3” will remain in the
display and a “B” will appear on the right side of the display.
This setting can be adjusted from 5 - 30 minutes.
5. Pressing status again will show the Salt Dosage. This can be
adjusted with the up and down arrows, the range is 3-15 lbs. for
the 9” controls and 5-24 lbs. on 12” controls. A number “4” will
appear at the bottom of the display while in this mode.
6. Press status again, this displays the Backwash Time in min-
utes. The setting can be adjusted between 5 and 40 minutes by
using the up and down arrows. A number “5” will appear at the
bottom of the display while in this mode.
7. Press status again to display the Brine/Rinse Time in minutes.
The settings can be adjusted using the up and down arrows
(37-85 min for 9”, 35-89 min for 12”). A number “6” will appear
at the bottom of the display while in this mode.
Press  to increase or
 to decrease
SSeettttiinngg TThhee MMiiccrroopprroocceessssoorr
The microprocessor senses when it is installed as a Soft-Minder or Aqua-Sensor
®
control. Adding or removing any
connection to the board, or flipping any of the dip switches will automatically reset the microprocessor to the factory
settings.
Press  to increase or
 to decrease
Press  to increase or
 to decrease
3B