Service manual

CULLIGAN HOUSEHOLD & COMMERCIAL CIRCUIT BOARDS
3
OFF
4. Timeclock Backup
Press the “STATUS” key. The display will blink “dIP4” for 3 seconds
and then show the current status. Toggle between “OFF” (Timeclock
backup is off) and “ON” (Timeclock backup is on) with the “+” or “-” key.
Note: Changing this setting will not change any of the programmed
values and will load the default Timeclock Backup value of 3 days.
Programming step 7 will be activated when this is set to On.
Note: This option will only be available when the flowmeter is plugged
into the control.
5. English or Metric
Press the “STATUS” key. The display will blink “dIP5” for 3 seconds
and then show the current status. Toggle between “En” (English units)
and “MET” (Metric units) with the “+” or “-” key.
6. 12 or 24 Hour Clock
Press the “STATUS” key. The display will blink “dIP6” for 3 seconds
and then show the current status. Toggle between“12 Hr” (12 hour
clock) and “24 Hr” (24 hour clock) with the “+” or “-” key.
7. 3/4" or 1" Meter
Press the “STATUS” key. The display will blink “dIP7” for 3 seconds.
Do not change setting from “3-4”
Note: The 3/4" meter setting is to be used with the Medallist
Series softener. The 1" meter setting is for future models.
12 : 00
PM
2:00
AM
Setting the Microprocessor
The microprocessor senses when it is installed as a Soft-Minder
®
control. Adding or removing any connection to
the board will automatically reset the microprocessor to the factory settings.
Step 1 – Programming Time of Day
Press the “STATUS” key.
The display will blink “tod” for 3 seconds and then change to time of
day with the “minutes” digits blinking.
Adjust the “minutes” digits with the “+” or “-” keys.
Press the “REGEN” key to blink the “hours” digits.
Adjust the “hours” digits with the “+” or “-” keys.
Press the “REGEN” key to cycle back to “minutes”
Note: The “hours” setting scrolls through 1-12 AM and 1-12 PM.
Make sure the proper AM or PM indicator is shown when setting
the time.
Step 2 – Programming Regeneration Time
Press the “Status” key after setting the time of day.
The display will blink “tor” for 3 seconds and then change to the
time setting with the “ones” digit blinking.
Adjust regeneration time as time of day above.
Note: This option will not show if the “dIP 2” option is set to immediate.
PPrrooggrraammmmiinngg
3-4