Service manual

The Culligan
®
Electronic control can be indexed through the various regeneration stages. For all steps, the
cycle numbers do not appear until the motor stops.
2.Press the REGEN button twice. The REGEN icon will
light and blink. A “1” will appear. The unit is now in the
BACKWASH position. The numbers to the right indicate
the time remaining for the cycle.
3.Press the UP arrow. A “2” will appear in the display.
The control is in the BRINE DRAW/SLOW RINSE cycle.
4.Press the UP arrow. A “3” will appear in the display.
The control is now in the FAST RINSE/BRINE REFILL
cycle.
5.Press the UP arrow. An “H” will appear in the display.
The unit is in the HOME position. The REGEN enuncia-
tor is no longer blinking. Note: A 30 minute delay will
show if an Aqua-Sensor
®
is connected to the circuit
board.
MMaannuuaall CCyycclliinngg
1.Press the STATUS button until the display is blank.
Push the UP arrow. An “H” will appear in the display.
The number 11 icon will light up. The control is in the
HOME position.
6.Press the STATUS key. Time-of-Day appears in the
display.
CULLIGAN HOUSEHOLD & COMMERCIAL CIRCUIT BOARDS
54