Service manual

CULLIGAN HOUSEHOLD & COMMERCIAL CIRCUIT BOARDS

Step 3 – Programming Salt Dosage

Press the “Status” key after programming regeneration time.

The display will blink “SLtP” if set to English or “SLtG” if set to Metric

for 3 seconds and then display the salt dosage.

Adjust the setting with the “+” or “-” key (3-24 lbs.)(0.5-10.0 kgs.)

Note: This option will not show if the control is set to Filter mode.

Step 4 – Programming Backwash Time

Press the “Status” key after programming salt dosage.

The display will blink “bw” for 3 seconds and then display the back-

wash time in minutes.

Adjust the setting with “+” or “-” key. (1-40 minutes)

Step 5 – Programming Brine Draw/Slow Rinse Time

Press the “Status” key after programming the backwash time.

The display will blink “br” for 3 seconds and then display the brine

draw/slow rinse time in minutes.

Adjust the setting with the “+” or “-” key. (35-99 minutes). See Table 5

for suggested brine draw/slow rinse times.

Note: This option will not show if the control is set to Filter mode.

Step 6 – Programming Gallons (Liters) or Days to Regeneration

Meter Mode —

Press the “Status” key after programming the brine draw/slow rinse

time.

The display will blink “CAPG” (“CAPL”) for 3 seconds and then display

the gallons or liters set point.

Adjust the setting with the “+” or “-” key. (10-9990 Gallons)

(40-37000 Liters)

Note: The programmed value must be multiplied by 10 to obtain the

actual setting. For example, if 87 is shown in the display, the control

will regenerate after 870 gallons have passed through the meter.

Timeclock Mode —

Press the “Status” key after programming the brine draw/slow rinse

time.

The display will blink “CAP” for 3 seconds and then display the number

of days between regenerations.

Adjust the setting with the “+” or “-” key. (1-42 days)

Step 7 – Programming Time Clock Backup

Press the “Status” key after programming the capacity.

The display will blink “tCb” for 3 seconds and then display the backup

number of days between regenerations.

Adjust the setting with the “+” or “-” key. (1-42 days)

Note: This option will only show if a meter is plugged into the control

and the timeclock backup option is turned on.

PPrrooggrraammmmiinngg