Operating instructions

SERVICE CHECK 19
The service check mode allows one to view the instantaneous flow rate, the days since the last regeneration, the
total number of regenerations, the regenerations in the past fourteen days, and the gallons remaining.
To enter the service check mode, follow these steps:
Service Check
1. Press the status key to move past steps 1-10 until the display is
blank.
2. Push the down arrow. The number '12' will appear only when the
Soft-Minder
®
meter is connected. The display reads the gallons
per minute flow rate. This screen will update with the current
meter reading every 6 seconds.
3. Press the down arrow. The number '13' and an "A" will light at the
bottom of the display. The display will indicate the number of
regenerations that have occurred in the last 14 days.
4. Press the down arrow. The number '13' and a 'B' will light at the
bottom of the display. The display will indicate the total number
of regenerations this control has cycled through.
5. Press the down arrow. The number '14' will light at the bottom of
the display. The number in the display indicates the number of
days since last regeneration.
6. Press the down arrow. The number '15' will be displayed if the
flow meter or Aqua-Sensor
®
is connected. For the controls with
the Soft-Minder
®
meter, the display indicates the gallons
remaining before the unit signals for regeneration (multiply the
displayed number by 10). For Aqua-Sensor
®
controls, the number
indicates the total minutes of the last brine rinse cycle.
NOTICE: Pushing the up arrow at any of these displays will immediately bring you to the control position
display, the number '11' will light at the bottom of the display. Pushing status will return to the time of day display.