Operating instructions

OPERATION 21
BEFORE LEAVING THE INSTALLATION SITE
Flush the sanitizing solution from the unit by running it to drain for a minimum of 40 gallons, or initiate a full
recharge cycle (by pushing the 'REGEN.' button twice).
Ensure that the brine tank has water to the level of the float. Add water to the tank with a hose or put the unit into
a full recharge so that the brine refill cycle will fill the tank with the proper amount of water.
The water heater will hold hard water for several days. Advise the customer that the existing water volume in the
tank will need to be used before the hot water is soft. If soft hot water is required immediately, refer to the water
heater owner's manual for the proper method of draining the water heater.
Explain the operation of the softener to the customer. Make sure the customer knows that there will be new sounds
associated with the recharging of the unit. Advise the customer to periodically check and replenish the salt supply.
Check the approiate softener model box on page 2 of the Owner's Guide. Fill in the hardness and number of people,
and then sign and date the corresponding performance data sheet. Leave the Owner's Guide with the customer.
Clean up the unit and installation site, removing any soldering, or pipe threading, residues from the equipment and
surrounding area with a damp towel.