User guide

State Drop-down menu

contents

Button label Action Next state

Change the width or height values. 2

Select a saved item from the drop-down menu. 3

Paper Size (width and height controls)

The width and height values can be changed either by typing numeric strings into the edit boxes, or

by using the up and down arrows.

Any entry that is greater than the maximum limits of the width and height control is rounded down to

the maximum valid entry, while any entry that is smaller than the minimum limits of the width and

height control is rounded up to the minimum valid entry.

If units are in millimeters, the custom media-size range minimum is the limit rounded up to the

nearest whole millimeter. The custom media-size range maximum is the limit rounded down to the

nearest whole millimeter. Any non-numerical entry reverts to the last valid entry. Width and height

entries are validated when the focus has changed.

The resolution of each control is one millimeter or one-tenth of an inch, depending on the current

measurement units. Clicking the up and down arrows increases or decreases the current value by

the increment amount (within the allowed range of values). The computer determines the rate at

which the values change.

Unit indicator labels change dynamically to indicate inches or millimeters, depending on the

measurement units the driver is currently using. To change measurement units, click the dynamic

Measurement Units button (either Use Inches or Use Millimeters).

Custom width and height control limits

The minimum media size for the HP LaserJet 1022 is 76.2 x 127 mm (3 x 5 inches) and the

maximum is 216 x 356 mm (8.5 x 14 inches). The following table summarizes media size limits for

each media-handling device.

Table 4-2 Host-based custom media sizes

Tray Dimensions Minimum Maximum

Tray 1 (10-sheet priority

input slot)

Width 76.2 mm (3 inches) 216 mm (8.5 inches)

Height 127 mm (5 inches) 356 mm (14 inches)

Tray 2 (250-sheet) Width 148 mm (5.83 inches) 216 mm (8.5 inches)

Height 210 mm (8.27 inches) 356 mm (14 inches)

Units

Select the Inches or Millimeters button to show the unit of measurement in either standard (inches)

or metric (millimeters).

The OK button closes the Custom Paper Size dialog box according to the logic in the following

table. In all cases, any custom media sizes that are successfully saved (and not renamed or deleted)

Table 4-1 Name drop-down menu text strings (continued)

54 Chapter 4 Windows driver features ENWW

Windows driver features