Specifications

GB-18

Adding Salt

If the water in your area is hard, deposits will form on your dishes and

utensils. This appliance contains a salt reservoir for you to reduce the

hardness of the water.

Please follow the steps below to pour the salt into the salt reservoir and

it must be set to correspond to the water hardness level in your area.

1. Remove the lower basket and unscrew the reservoir cap.

2. Fill the reservoir with approximately 500ml of water (first use only).

3. Place the funnel provided over the salt reservoir.

4. Pour in approximately 1.2kg of dishwasher salt depending on the

brand used.

5. Clean any excess salt from around the reservoir opening and then

screw the cap on again firmly.

6. Run the “Rapid” wash programme immediately (without any

crockery in the dishwasher) to remove any traces of salt from the

compartment.

OPEN

open

• The salt warning light will illuminate when the reservoir

is running out of salt and requires re-filling.

• The salt warning light will cease to illuminate within a

few days depending on how quickly the salt dissolves.

• If you select to use detergent tablet, you do not need to

add rinse aid into the rinse aid reservoir.

CID45B10_IB_110426.indd 18 4/26/11 8:15 PM