Specifications

GB-26
Internal Care
Filtering System
The filtering system in the base of the wash cabinet captures large particles of suds solution. Build up of
these particles may cause the filters to block. Check the condition of the filters regularly and clean them if
necessary under running water.
Follow the steps below to clean the filters in the wash cabinet.
1. Ensure the dishwasher is switched off.
2. Turn the coarse filter anti-clockwise and gently lift it out.
3. Gently lift the coarse and fine filter out.
4. Rinse all the filters under running water, including the filter cylinder, and then refit all filters in the
following order.
5. Gently refit the main filter back with care.
6. Gently rescrew the course and fine filter in clockwise direction.
Cleaning After Use
External Care
The Door and the Door Seal
• Clean the door seals regularly with a soft damp cloth to remove food deposits.
• When the dishwasher is being loaded, food and drink residues may drip onto the sides of the
dishwasher door. These surfaces are outside the wash cabinet and are not accessed by water from the
spray arms. Any deposits should be wiped off before the door is closed.
The Control Panel
If cleaning is required, the control panel should be wiped with a soft damp cloth ONLY.
• To avoid penetration of water into the door lock and electrical components, do not use a spray
cleaner of any kind.
• Never use abrasive cleaners or scouring pads on the outer surfaces because they may scratch the
finish. Some paper towels may also scratch or leave marks on the surface.
• Do not over tighten the filters. Put the filters back in the filter cylinder in sequence securely,
otherwise the residue could get into the system and cause a blockage.
• NEVER use the dishwasher without the filters in place. Improper replacement of the filters may
reduce the performance level of the appliance and damage dishes and utensils.
Filter cylinder
without the lters
CID45B10_IB_110426.indd 26 4/26/11 8:15 PM