Manualshelf

Installation Guide

ManualsBrandsCustom Building Products ManualsFlooringFusion Pro #105 Earth 1 Gal. Single Component Grout
12
Fusion Pro
®
Single Component
®
Grout
Installation Guide
1
Moisten Tile
(Skip this step if a water soluble grout
release, such as AquaMix
®
Grout
Release was applied to the tile. Perform
this step if the tile was pre sealed.)
Moisten the tile with a lightly damp
sponge. Do not allow any water to
puddle on the surface of the tile or
in the grout joints.
Apply Grout Release or Pre-Seal Tile
CUSTOM recommends using a grout release or pre-sealing the tile. This will significantly ease clean-up and help eliminate grout haze.
2
Spread Grout
Working in small areas, no greater than
20 sq. ft, spread grout and fill joints for
3-4 minutes
only.
Start off with a smaller area the first time
you use Fusion Pro, or if conditions are
hot or dry.
Do not allow Fusion Pro to dry or skin over.
Begin the clean up steps immediately.
3
Remove Excess Grout
Using the edge of the float, drag
diagonally across the tile to remove
the majority of excess grout.
4
Lightly Dampen Surface
Using a lightly damp grout sponge,
dampen the entire 20 sq. ft. of tile
where grout was just applied.
5
Loosen Grout Adhered to Tile
Use a lightly damp grout sponge held
flat against the tile. Working the entire
20 sq. ft. area, use a circular motion and
moderate pressure to loosen any grout
that is still adhered to the tile surface.
Limit the number of times you rinse out
the sponge at this stage. The residue
on the sponge will help break up and
soften residue on the surface of the tile.
Do not overscrub as it may pull grout
out of the joints. Grout joints must
remain full.
6
Shape Joints and
Wipe off Grout
Once grout on tiled surfaces has been
loosened, thoroughly rinse and wring
out the sponge.
Wipe the sponge once across the
grouted tile diagonally to clean the
face of the tile and create smooth
consistent grout joints.
Flip the sponge over and continue
cleaning the next area.
Rinse, wring and repeat until you have
dragged a clean sponge face across
the entire 20 sq. ft. area of freshly
grouted tile.
7
Final Clean-Up
Drag a moderately damp microfiber
towel diagonally across the surface
for final clean up.
Flip the towel to the other side and
continue to clean the entire 20 sq. ft.,
rinsing as needed.
WEAR IMPERVIOUS GLOVES, SUCH AS NITRILE, AND EYE PROTECTION.

Summary of content (2 pages)