Service manual

Cybex Eagle 11070 Arm Curl Owner’s Manual
Assembly
Page 4-5
9. Install weight plate decals.
NOTE: You have the option to use pounds, kilograms or both.
Slowly and carefully peel off back side of decal. See A.
Figure 14. NOTE: When peeling off back cover, make
sure that the decals remain attached to the front sticker.
Align holes in decal with appropriate holes in weight B.
stack. NOTE: Do not allow the adhesive to touch
weight stack at this time.
Insert a guide pin through each hole of the template. C.
NOTE: A guide pin can be anything that fi ts through the
weight stack hole, such as a weight stack selector pin.
Carefully align decal and rub it onto weight plates. D.
Carefully remove front side, leaving decals adhering E.
to weight plates. See Figure 15.
NOTE: It is important that you perform regular inspection
and maintenance activities on your equipment. See
the CYBEX Eagle Owner’s Manual for inspection and
maintenance activities. If you do not have a CYBEX
Eagle Owner’s Manual or if you have any questions
or concerns, call CYBEX Customer Relations at
888-462-9239.
10. Verify proper operation
11. Anchor machine to the fl oor.
Securely anchor machine to the fl oor using the anchor holes provided in each machine. A.
NOTE: Cybex is not responsible for the actual anchoring of equipment. Consult with a professional contractor.
NOTE: Use fasteners having a minimum of 500 lbs. tensile capacity (3/8” grade 2 bolts or better).
NOTE: If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or frame not
in contact with surface using fl at washers.
180
81.0
144.0
135.0
126.0
117.0
10
8.0
200
99.0
90.0
300
280
260
240
220
320
340
153.0
180.0
360
171.0
162.0
400
380
20
9.0
72.0
63.0
54.0
45.0
36.0
40
18.0
140
120
100
80
60
160
Figure 15
Pounds
Weight Stack
Guide Rod
Kilograms
Figure 14
Front
Back