Owner`s manual

Cybex 425T Treadmill Owner’s Manual
Operation
Page 3-4
10. Press the Pause/Stop key at any time to stop your workout. Press Pause/Stop once to
end your workout and begin your Workout Review. As you press Pause/Stop once, the
treadmill belt will stop. Press Pause/Stop a second time to clear the Workout Review,
return to Dormant Mode.
11. If the e-stop key is removed during a workout, the drive motor power shuts off
immediately, causing the belt to stop. The right window changes to “OFF” and the left
window shows a flashing pattern of “
o
” and “
o
”. Replacement of the e-stop key causes
Workout Review to begin. Pressing Quick Start will resume your workout.
12. When you complete a program the treadmill begins a countdown, “3...2...1,” and sounds
a tone for each count. The belt slows to a stop and Workout Review displays in the center
window for the preset time or until you press the Pause/Stop key.
13. The treadmill returns to Dormant Mode.
Stopping the Treadmill
Press Pause/Stop once to pause your workout for up to 20 seconds (or time set for idle) and to enter the
Workout Review. The belt will stop and workout data will remain in memory for the duration of pause.
Press the Quick Start key within 20 seconds to continue your workout and add to the time you already
accumulated. If the Quick Start key has not been pressed during the duration of pause, workout data will
be cleared and the display will change to Dormant Mode.
Figure 1
8. Press the Speed + — keys to change the belt speed at any time. The right display will
show the set speed.
9. Press the Incline
Λ V keys to change the incline at any time. The left display will show the
current incline only when incline keys are used, then revert to time.