Operation Manual
26 27
c)
II.-II APPLYING OF THE LUBRICANT
b)
a)
Rear Wheel - Spray from the rear side of the buggy in the
space between the rim and the housing on both sides. Let the
lubricant work its way into the system for approx. 10 seconds
and then turn both rear wheels.
Front Wheel - Spray in the space between the rim and the
housing on both sides. Let the lubricant work its way into
the system for approx. 10 seconds and then turn both front
wheels.
Should this not avoid the squeaking, please remove the rim
cap and apply the spray on the axle.
Suspension - Apply some lubricant between the suspension
slider and the housings.
II.-I CHECK OF WHEEL SYSTEMS
a) Wheel system must be cleaned before applying the lubricant.
b) Wheel system must not be broken or damaged. To avoid squeaking noises on your
CYBEX buggy only use WD 40 and follow the instructions below. Do not use any other
kind of lubricant! Before applying the lubricant, in order to avoid any stains on the fabrics,
please protect them by holding a cloth or carton in front of them. Please pay special
attention to not apply the lubricant on any other part of the stroller (fabrics, tubes, etc.).
CLEANING
Do not use abrasives to clean the frame! Use a damp cloth and a mild detergent and dry
thoroughly.
Should the stroller be exposed to salt water, please rinse it down with fresh (tap) water as
soon as possible afterwards.
The seat cover can be machine washed at max. 30°C with a mild detergent on a gentle cycle
setting. The canopy should be washed by hand with a mild detergent (not warmer than 30°C)
See care labels for details. Do not use the washing machine or tumble drier. Dry thoroughly
before reuse.
All CYBEX fabrics have been tested, but when the stroller is very wet, the water may
permeate the lining through the bottom edges and seams and leave water stains on the
upholstery. We advise you to use a rain cover to avoid this. Also please do not fold or store
the product while wet. If the stroller is wet, allow to dry with the hood extended. Never store in
a damp environment as this can cause mildew to form.
DISPOSAL
When you are done using your CYBEX TWINYX, a proper disposal is important. Garbage
disposal can be different in every country. Please contact your local waste management company
to make sure you are taking the right steps to dispose of the CYBEX TWINYX. Always follow the
disposal regulations of your country.
SERVICE
In general a Cybex buggy should run smoothly without any problems. A dry and/or dusty
environment can have a negative effect on the wheel systems. To avoid this it is very important
that the wheel systems will be regularly checked, cleaned and lubricated. This will ensure a
smooth operation of the stroller in daily use. Please follow the instruction below to maintain the
wheel systems (wheel axles & suspension system).
Do not tumble dry and do not expose to direct sunlight! Do not iron!
EN 1888:2003 + A1/A2/A3:2005.
!
WARNING
EN