Operation Manual
34 35
Slightly fold the stroller to reduce
tension.
Remove the canopy from the stroller, if
attached.
Remove the seat cover hooks (3) from
both sides of the frame.
Open the press buttons (4) of the two
straps connecting the seat side panels
with the rear tube.
(5)
velcro covering both sides of the seat
Feed the strap with the slider (6) of the
central harness buckle through the hole
in the seat fabric.
Feed the loops at the end of the shoulder straps through the triangle in the
backrest (7).
Feed the shoulder straps through the holes in the seat fabric (8).
Open the press buttons on the left and the right side of the seat unit. These are
Pull the seat cover over the harness adjustment button of the seat.
Slide the fabric from the seat base tubes.
the seat tubes slide back into the pockets inside the seat cover.
12. REMOVING THE SEATCOVER
d)
e)
To release the harness buckle, simply squeeze
both sides of the harness buckle together. This
will then release the buckle tongues.
The length of the crotch strap is adjusted by
moving the slider up or down.
a)
11. ADJUSTING THE HARNESS SYSTEM FOR NEWBORNS
Release the loops located at the end of the shoulder
straps from the metal triangle attached to the belt
system. The triangle is situated at the bottom of the
backrest underneath the seat cover.
Completely pull the shoulder straps out of the holes of
the backrest and the fabric seat cover.
Feed the shoulder straps through the two lower holes
in the seat cover. Make sure to feed the straps back
through the sloted holes of the plastic backrest mecha-
nism and re-attach them to the
triangle.
To adjust the length of the shoulder straps for newborns
please use the the inner loop of the shoulder strap ends
and attach them to the metal triangle. Switch back to
the lower holes as soon as the shoulder straps do no
a)
EN