Specifications

Once in the command line interface (CLI) type "telnet", a space, then the

IP address of the unit you wish to control, a space and "23", then hit enter.

Note: The IP address of the Matrix can be displayed on the device's LCM

monitor by pressing the Menu button twice.

This will bring us into the device which we wish to control. Type "HELP" to

list the available commands.

Type “IPCONFIG” To show all IP congurations. To reset the IP, type “RSTIP”

and to use a set static IP, type ”SETIP” (For a full list of commands, see

Section 6.7).

Note: Any commands will not be executed unless followed by a carriage

return. Commands are not case-sensitive. If the IP is changed then the IP

Address required for Telnet access will also change accordingly.