Specifications

① Power: Press to turn the system on/off.

② ID: Press the Transmitter and Receivers “ID” button for 2 seconds to connect

the systems. These systems were already connected before leaving the

factory, so you do not need to reset them again unless the system cannot

link up properly. Press the ID button for more than 10 seconds to switch to a

different mode (Broadcast/Unicast). When the green LED is lit it means the

system is under Unicast mode and when the red LED is on, it means the

systems has been switched to Broadcast mode. The factory default is

Unicast mode and it is suggested to use this for household use. It is not

necessary to press both the Transmitter and Receiver's ID button at the same

time. Note: Due to the nature of the transmission, Broadcast mode has no

uplink so bi-directional communication between Transmitter and Receiver is

not possible. This results in the following limitations:

③ IR sensor.

④ Power: The LED will illuminate when power ON.

⑤ Link: When under search mode the LED will flash repeatedly and during the

signal linking stage the LED will slowly flash. When the LED has been switched

on and no longer flashes it means the signal has been properly linked.

4.2 Receiver side

4.2.1 Front Panel

4.1.2 Rear Panel

① HDMI 1/2/3 Inputs: Connect each of the input ports to the HDMI output

of your source equipment such as DVD/Blu Ray players or set-top-boxes.

② Power: Plug the 5V DC power supply into this unit and connect the

adaptor to an AC outlet.

1 2

HDMI3

HDMI2

HDMI1

DC 5V

1 2

PowerIR Link

Power

CWHDI-RX Receiver