SDS

D8302476 v1.0
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
6. Accidental release measures
Move containers from spill area. Approach release from upwind. Prevent entry into
sewers, water courses, basements or confined areas. Avoid dust generation. Do not
dry sweep. Vacuum dust with equipment fitted with a HEPA filter and place in a closed,
labeled waste container. Dispose of via a licensed waste disposal contractor. Note:
see Section 1 for emergency contact information and Section 13 for waste disposal.
Large spill
:
Move containers from spill area. Avoid dust generation. Using a vacuum with HEPA
filter will reduce dust dispersal. Place spilled material in a designated, labeled waste
container. Dispose of via a licensed waste disposal contractor.
Small spill
:
7. Handling and storage
Conditions for safe storage,
including any
incompatibilities
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Keep container tightly closed and sealed until
ready for use. Containers that have been opened must be carefully resealed and kept
upright to prevent leakage. Do not store in unlabeled containers. Use appropriate
containment to avoid environmental contamination.
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Do not ingest. Avoid
contact with eyes, skin and clothing. Keep in the original container or an approved
alternative made from a compatible material, kept tightly closed when not in use. Empty
containers retain product residue and can be hazardous. Do not reuse container.
:
Precautions for safe handling
Not applicable.
8. Exposure controls/personal protection
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: safety glasses with side-
shields.
Eye/face protection
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Hygiene measures
:
Control
Individual protection measures
Occupational exposure limits
Skin protection
5/12
4/18/2017
Date of issue
:
SDS #
FF8299221
(D8302476) US
:
Code #
D8302476 v1.0
: