User manual

6 Command Line Interface D-Link Web Smart Switch User Manual
9
9
5
5
reboot
Purpose To reboot the Switch. If the Switch is a member of a stack, it may
be rebooted individually, without affecting the other members of
the stack.
Syntax
reboot
Description
The reboot command
reboots the system. All network
connections are terminated and the boot code executes.
Parameters None.
Restrictions None.
Example usage:
To restart the Switch:
DGS-1210-52> reboot
% Device will reboot, please wait a few minutes to re-login.
DGS-1210-52>
reset config
Purpose To reset the Switch to the factory default settings.
Syntax
reset config
Description All configurations will be reset to the default settings.
Parameters
None.
Restrictions None.
Example usage:
To restore all of the Switch’s parameters to their default values:
DGS-1210-52> reset config
% Device will reboot after reset configuration successfully.
DGS-1210-52>
show ipif
Purpose To display the configuration of an IP interface on the Switch.
Syntax
show ipif
Description
The show ipif command displays the current IP address of the
switch.
Parameters None.
Restrictions None.
Example usage:
To display IP interface settings:
DGS-1210-52> show ipif