User manual

6 Command Line Interface D-Link Web Smart Switch User Manual
9
9
3
3
DGS-1210-52>
config ipif system
Purpose To configure the System IPv6 interface.
Syntax
config ipif system { ipv6 ipv6address <ipv6networkaddr> |
dhcpv6_client [enable | disable] }
Description
The config ipif s ys tem command configures the System IPv6
interface on the Switch.
Parameters
ipv6 ipv6address <ipv6networkaddr> − Use this parameter to
statically assign an IPv6address to this interface. This address
should define a host address and a
network prefix length.
Multiple IPv6 addresses can be configured for a
single IP
interface. Ex: 3ffe:501:ffff:100::1/64. The /64 represents the prefix
length of the IPv6 addresses.
dhcpv6_client [enable | disable] − Specify the DHCPv6 client to
be disabled or enabled.
Restrictions None.
Example usage:
To configure the IPv6 interface System:
DGS-1210-52> config ipif S ystem ipv6 ipv6address 3ffe:501:ffff:100::1/64
Success.
DGS-1210-52>
logout
Purpose To log out a user from the Switch’s console.
Syntax
logout
Description
The logout command terminates the current user’s session on
the Switch’s console.
Parameters None.
Restrictions None.
Example usage:
To terminate the current user’s console session:
DGS-1210-52> logout
NOTE: Save your configuration changes before
logging out.
ping
Purpose To test the connectivity between network devices.
Syntax
<ipaddr>