Installation & Assembly_2

Installation Instructions for your D’Vontz Square or

Round Bar and Prep Copper Sink

Items needed for Installation:

• A quality 100% clear silicon sealer.

• Sink drain for appropriate drain diameter.

• Soft cotton rag.

• Pencil

• Tape Measure

Directions:

NOTE: During the installation of this product, the only sealant or adhesive that is

Manufacturer Approved is a 100% Silicone based product. Failure to use Kitchen and

Bath 100% Silicone based products will VOID ALL manufacturer warranties and

manufacturer finish warranties. Specifically, the use of Plumbers Putty is EXPRESSLY

PROHIBITED and will VOID ALL manufacturer warranties and manufacturer finish

warranties.

Drop In Installation:

• Determine location on countertop for sink. Turn sink upside down and place on

countertop. Lightly trace the outside edge of your sink with a pencil. Remove sink and

scribe line with pencil 1” inside outside line. See Fig. A. Cut countertop to this

dimension. Since these sinks are manufactured by hand, we are unable to provide a

template due to variations that occur in size.

Fig. A

Countertop Cut Line

Sink Trace Line

PAGE 1
Installation Instructions for your D’Vontz Square or Round Bar and Prep Copper Sink Items needed for Installation: • • • • • A quality 100% clear silicon sealer. Sink drain for appropriate drain diameter. Soft cotton rag. Pencil Tape Measure Directions: NOTE: During the installation of this product, the only sealant or adhesive that is Manufacturer Approved is a 100% Silicone based product.
PAGE 2
• Once countertop hole is cut, set sink inside hole and center. Ensure sink flange sits flat on top countertop. • Before setting sink in countertop, prepare and attach drain to sink. Use silicone sealer under drain flange. After tightening tailpiece remove excess sealer. • Run a ¼” bead of silicon sealant inside of pencil line. Carefully set sink into countertop hole and sealant.